User`s guide

Us e r 's GU i d e — 41



t
after entering it in order





Thread Size TPI/Pitch
 
8, 10, 12, 14
less than 100
  less than 100
Metric  
Note: Entries outside of the ranges mentioned above will result in an
Entry Error.
The following tables list the available Thread characteristics



Thread
Classication section).
Internal Thread
 
 
 
 
 
* If the resulting hole size is greater than 2 Inches or 50 mm, the actual
hole size will be displayed instead of adjusting to the closest Drill Size.
(cont’d)