User's Guide

User’s Guide — 19
Multiplication
Period x Period = Error
Point x Period = Error
Point x Point = Error
Period x Number = Period
Point x Number = Error
Division
Period ÷ Period = Number
Period ÷ Number = Period
Period ÷ Point = Error
Point ÷ Period = Error
Point ÷ Number = Error
Point ÷ Point = Error
Time Values
If the “
SECS” preference setting is “On”,
the display shows a place holder (00)
for seconds even if the ß key was
not used.
If set to “
OFF”, you must press the ß
key to display the seconds placeholder.
If entering points in time, it is not
necessary to use the : key. See
Method 5 for an alternate method.
When entering time values, you may
use any of the following entry methods.
H o w e v e r, r e m em b e r t o a l w a y s e n t e r
Hours first, then Minutes, then Seconds.