User Manual

Important Note!
Unless otherwise indicated, all sample prob-
lems in this section assume the ScheduleCalc
is in its default state. If not, use [Conv] [x]
to reset the calculator.
Time Values
If the “SECS” preference setting is “ON”,
the display shows a place holder (00)
for seconds even if the [Sec] key was
not used.
If set to “OFF”, you must press the [Sec]
key to display the seconds placeholder.
If entering points in time, it is not nec-
essary to use the [:] key. See Method 5
for an alternate method.
When entering time values, you may use
any of the following entry methods.
However, remember to always enter
hours first, then minutes, then seconds.
Note: In the following examples, the first
value shown is with the “
SECS ” setting
“
OFF .” The second value is with the “ SECS ”
setting “
ON .”
Using the ScheduleCalc
18—ScheduleCalc™