Specifications

Crestron TPS-12G/15G/17G-QM-L Isys
®
G-Series Wall Mount Touchpanels
3. The TPS-12G-QM-L can be powered via the 24 VDC jack or the NET port. Be sure to use a Crestron
approved power supply as another may cause damage. The TPS-17G-QM-L connects to the Cresnet
control network and remote power supply via the TPS-17G-QM/-L-IMC Power Interface Module
(included with the TPS-17G-QM-L).
CAUTION: Do not connect the TPS-17G-QM-L directly to the Cresnet network bus.
4. This port not used by the TPS-15G-QM-L, which instead, must be powered via Cresnet connector
only, using CNPWS-75 or C2N-SPWS300 power supply (sold separately). The TPS-17G-QM-L may
be powered via this port or via the TPS-17G-QM/-L-IMC Power Interface Module (included) using
the power supply provided.
5. The eight-pin RJ-45 QuickMedia transport port accepts CAT5E/CAT6 carrying audio, video and
microphone signals. The QM input port conforms to the 568B wiring standard. Refer to the following
table for connector pinouts.
RJ-45 PIN
NUMBER
WIRE COLORS
(EIA 568B)
QM ASSIGNMENT: RGB
QM ASSIGNMENT: COMPOSITE,
S-VIDEO, COMPONENT AND
AUDIO
1 WHITE/ORANGE
- RGB RED
- CHROMINANCE (- P
r
)
2 ORANGE
+ RGB RED
+ CHROMINANCE (+ P
r
)
3 WHITE/GREEN
- RGB GREEN
- LUMINANCE (- Y)
4 BLUE
+ DIGITAL AUDIO
+ AUDIO
5 WHITE/BLUE
- DIGITAL AUDIO
- AUDIO
6 GREEN
+ RGB GREEN
+ LUMINANCE (+ Y)
7 WHITE/BROWN
- RGB BLUE
- COMPOSITE (- P
b
)
8 BROWN
+ RGB BLUE
+ COMPOSITE (+ P
b
)
6. Refer to “Pushbutton Programming” on page 60 for details. For reset, press and hold button for 10
seconds.
Operations Guide – DOC. 6356B Isys
®
G-Series Wall Mount Touchpanels: TPS-12G/15G/17G-QM-L • 21