Manual

There are two methods for programming Custom Scales into
your Ultra Scale Master. “Measured Custom Scales” allow
you to measure a specifi ed Length and assign the known
value. “Entered Custom Scales” allow you to enter and set a
known scale that is not included within the available built-in
scales of the Ultra Scale Master.
One Custom Scale can be stored in Imperial and Metric
Modes for a total of two Custom Scales. Once a Custom
Scale has been set in either mode, it is retained until a new
scale is stored in its place or until an All Clear or Reset is
performed. Switching between Imperial and Metric Modes
does not clear stored Custom Scales.
SETTING A MEASURED CUSTOM SCALE
CUSTOM SCALES
1. Press [MODE] until “CUST” is displayed.
2. Press [SET] then [SCALE] to begin setting the Custom
Scale. The display prompts you to enter Point-1.
3. Place the crosshairs over the start point of the line and
press [MEASURE]. You are prompted to enter Point-2.
4. Place the crosshairs over the end point of the line and press
[MEASURE]. The display shows “0,000-00” for Imperial
Mode and “00,000.0” is displayed for Metric Mode.
The following example is shown in Imperial Mode. The displays will be slightly different if in Metric Mode.
(Cont’d)
USER’S GUIDE — 25