User Manual

26 — ElectriCalc Pro
To Set Ambient Temp. to °C or °F:
÷ (2nd press of ÷) AMB° 30 °C
+ AMB° 86 °F
To Set Length to Feet or Meter:
÷ (3rd press of ÷) FEET 1.
+ MET 1.
Default Settings
When you first receive your calculator,
it is pre-set to the default settings listed
below. You can always return your
calculator to these default values by per-
forming a full reset (see previous page)
Ambient Temperature 30°C
Insulation Rating 60°C
Material Copper (Cu)
Phase 3Ø
Volts 240 V
Efficiency 100%
Power Factor 100%
Length Units Feet
Voltage Drop Percent 3%
Wire Environment Raceway
(vs Free Air)