Use and Care Manual

User’s GUide — 17
EnTERinG dimEnSionS
Linear Dimensions
When entering feet-inch values, enter dimensions from largest
to smallest — feet before inches, inches before fractions. Enter
fractions by entering the numerator (top number), pressing 
(Fraction Bar key) and then the denominator (bottom number).
Note: If a denominator is not entered, the fractional setting
value is used.
Examples of how linear dimensions are entered (press 
after each entry):
DIMENSIONS KEYSTROKE
5 feet  
5 feet, 1 ½ inches     
17.5 meters  7   
m
1250 millimeters    
m
Square and Cubic Dimensions
Examples of how square and cubic dimensions are entered
(press  after each entry):
DIMENSIONS KEYSTROKE
14 square inches   
11 square feet   
3.3 square meters    
m m
3 cubic feet  