Use and Care Manual

User’s GUide — 13
 Pipe Material – Denes the Pipe Material. (Steel,
Stainless Steel, Brass, Aluminum, Cast Iron, PVC
or Copper).
 Elbow Type – Denes the type of radius (long or
short) and whether a factory or eld cut 45˚ Butt
Weld elbow is being used. Default value is Butt
Weld – Long.
 Pipe Size – Enters the nominal Pipe Size and
provides data pertaining to the entered size.
  Pipe Type – Denes the Pipe Type based on Pipe
Material.
  Cutback – Calculates pipe Cutback after Bend
Angle and Offset are entered.
  Rolling Offset (Roll)– Calculates Rolling Offset
pipe length.
  Flow – Enter or calculate volumetric Flow Rate
through a pipe.
  Velocity – Enter or calculate Velocity and convert
between feet per second, feet per minute, and
meters per second.
  Pressure – Enter Pressure value. Calculate
Pressure loss. Convert between units of pressure.
  Force – Enter or calculate Force and convert
between lbf, newton.
  Area – Enter pipe area for use in Flow, Velocity,
Pressure, and Force calculations. Calculate Area
given values for Flow/Velocity or Force/Pressure.