Use and Care Manual
12 — PiPe Trades Pro™
Pipetting Project Keys
Travel
Slope
Offset
Angleº
Angle/Slope – Enters or calculates a linear Slope,
Slope Angle, or Percent Grade. The linear slope
is the amount of "Offset" over 12 inches of "Run."
Values may be entered as:
● a Dimension:
● an Angle or Degrees:
● a Percentage (percent grade): 7
Once an angle or slope has been entered,
consecutive presses of will convert to the
remaining formats listed above.
Take-Out (T.O./Arc) – Used to enter or solve
tting Take-Outs when calculating pipe cut lengths.
Calculates inner, center, and outer arc lengths for
marking eld cut ttings.
Calculates or enters the Offset (Rise).
Welder's Gap – Denes the Welder's Gap
subtracted from the end to end pipe length
calculation. Default value is 1/8", 0 is a valid value.
Enters or calculates the Run.
Enters or calculates the Travel (Diagonal).