pocket reference guide

Pocket RefeRence Guide — 29
1.EnterPipeSize:
6   STD SIZE 6 INCH
2.ChangethedefaultWelder’sGapfrom
1/8”to3/32”:
   2   * GAP 0-3/32 INCH
3.EnterOffset:
2 4   OFST 24 INCH
4.Entertheadvance:
 2   (Advance) RUN 32 INCH
5.EntertheRollandcalculatethepipe
lengthandunknownbendangle:
1  
  (Roll) LNTH 42-1/16 INCH
 CUT 35-1/4 INCH
 TO 3-5/16 INCH
 GAP 0-3/32 INCH
 FIT° 40.46°
 IARC 4-1/32 INCH
 CARC 6-11/32 INCH
 OARC 8-11/16 INCH
*Settingwelder'sgapto3/32inchwill
temporarilysettheoutputsto1/32fractional
resolution.Tokeepoutputsintheircurrent
1.EnterOffset:
1 7   OFST 17 INCH
2.Entertheadvance:
2    (Advance) RUN 28 INCH
3.EntertheRollandcalculatethepipe
lengthandunknownbendangle:
6  1  2
  (Roll) LNTH 33-3/8 INCH
 FIT° 33.02°
Continuepressingthe keytoviewall
relatedvalues.
Rolling Offset – Cut Length
Find the end-to-end pipe length for a rolling
pipe offset with a 13” Roll, a 24” Offset,
and an advance of 32”. The bend angle is
unknown. This example assumes 6” Steel,
factory made long radius butt weld elbows
are used with a Welder’s Gap of 3/32” (the
default is 1/8”).
Note: AllTake-Outcalculationsarebased
onCarbonSteelO.D.SeetheCut Length
– Known Take-Out Valueexampletosolve
CutLengthsforknownTake-Outvalues.
KEYSTROKE DISPLAY
  ALL CLEArEd
(cont'd)
(cont'd)
KEYSTROKE DISPLAY
KEYSTROKE DISPLAY