pocket reference guide

Pocket RefeRence Guide — 27
Note: ToreturntheWelder’sGaptothe
default1/8”,press toresetyour
calculatorbacktodefaultvalues.
Rolling Offset – Known Bend Angle
Find the center-to-center travel for a rolling
pipe offset with a 4” Roll and a 24” Offset.
KEYSTROKE DISPLAY
  ALL CLEArEd
1.EnterOffset:
2 4   OFST 24 INCH
2.Enterbendangle:
4 5  /
_
Ø 45.00º
3.EntertheRollandcalculatethepipelength:
4    (Roll) LNTH 34-7/16 INCH
Continuepressingthe keytoviewall
relatedvalues.
Rolling Offset – Unknown Bend Angle
Find the center-to-center travel for a rolling
pipe offset with a 6-1/2” Roll, a 17” Offset, and
an advance of 28”. The bend angle is unknown.
KEYSTROKE DISPLAY
  ALL CLEArEd
(cont'd)
1.SelectStainlessSteel:
  MATL S.StEEL
2.EnterPipeSize:
6   40 SIZE 6 INCH
3.Enter0forWelder'sGap:
   (Welder'sGap) GAP 0 INCH
4.EnterOffset:
1   
OFST 10 INCH
5.EnterRun:
1 2   RUN 12 INCH
6.Findthepipelength:
 TRAV 15-5/8 INCH
 CUT 9-1/8 INCH
 TO 3-1/4 INCH
 GAP 0 INCH
 FIT° 39.81°
 IARC 3-15/16 INCH
 CARC 6-1/4 INCH
 OARC 8-9/16 INCH
The cut length for the pipe is 9 and 1/8
inches and bend angle is 39.81°. Included
in the outputs are the arc lengths to be used
to cut your butt weld elbow to the calculated
bend angle. These are inner arc length of 3
and 15/16 inches, center arc length of 6 and
1/4 inches, and outer arc length of 8 and 9/16
inches.
(cont'd)
KEYSTROKE DISPLAY