pocket reference guide

Pocket RefeRence Guide — 25
1.EnterOffset:
1 6   OFST 16 INCH
2.EnterRun:
2 7   RUN 27 INCH
3.Findthepipelength:
 TRAV 31-3/8 INCH
4.Findthebendangle:
 /
_
Ø 30.65°
Simple Offset – Cut Length
Find the cut length (end-to-end) for a pipe
offset with a 10” Offset and a 12” Run.
The bend angle is unknown. This example
assumes 6” Steel, factory made long radius
butt weld elbows are used. The following
example shows an optional override of the
Welder’s Gap when working with Stainless
Steel.
Note: AllTake-Outcalculationsarebased
onCarbonSteelO.D.SeetheCut Length
– Known Take-Out Valueexampletosolve
CutLengthsforknownTake-Outvalues.
KEYSTROKE DISPLAY
  ALL CLEArEd
(cont'd)
(cont'd)
KEYSTROKE DISPLAY
KEYSTROKE DISPLAY
  (Default) BW-L EL. tYPE
 BW-S EL. tYPE
 FC-L EL. tYPE
 FC-S EL. tYPE
 (Default) BW-L EL. tYPE
Simple Offset – Known Bend Angle
Find the center-to-center travel for a pipe
offset with a 24” Offset.
KEYSTROKE DISPLAY
  0.
1.EnterOffset:
2 4   OFST 24 INCH
2.Enterbendangle:
4 5  /
_
Ø 45.00°
3.Findthepipelength:
 TRAV 33-15/16 INCH
Simple Offset – Unknown Bend Angle
Find the center-to-center travel and unknown
bend angle for a pipe offset with a 16” Offset
and 27” Run.
KEYSTROKE DISPLAY
  0.