Owner's manual

USER’S GUIDE —25
ENTERING DIMENSIONS
Entering Linear Dimensions
When entering Feet-Inch-Fraction values, enter dimensions from
largest to smallest — e.g., Feet before Inches, Inches before
Fractions. Enter Fractions by entering the numerator (top), pressing
/ (Fraction bar key) and then the denominator (bottom).
Note: If a denominator is not entered, the fractional setting value is used.
Examples (press o after each one):
DIMENSION KEYSTROKES
5Feet1-1/2Inch 5f1i1/2
17.5 Meters 17•5m
32 Millimeters 32Çm
Entering Square/Cubic Dimensions
Your calculator lets you easily enter Square and Cubic values.
Simply press a dimensional unit key two times to label a number as
a Square value, or three times to label a Cubic value.
Note: If you pass the desired dimensional format, keep on pressing the dimensional
unit key until the desired result is displayed.
Enter Square and Cubic dimensions in the following order:
(1) Enter numerical value (e.g., 100).
(2) Press desired unit key (e.g., f) to label value as “linear.”
KEYSTROKE DISPLAY
oo 0.
100f 100
FEET
(3) Second consecutive press of unit key (e.g., f) labels value as
“Square.”
KEYSTROKE DISPLAY
oo 0.
100ff 100 SQ FEET
(4) Third consecutive press of unit key labels value as “Cubic.”
KEYSTROKE DISPLAY
oo 0.
100fff 100 CU FEET
Note: Feet-Inch format cannot be used to enter Square or Cubic values.