Hardware manual

iii
Who Should Read This Document?
This document is intended to be read by EGM 3530-xx TeleFlow users who are
using the standard software accompanying the TeleFlow™.
It assumes that the TeleFlow™ has been installed, and that all network cabling has
been connected and tested.
This document assumes familiarity with the following subjects:
The requirements of their particular process or application.
ACCOL programming. Anyone modifying the TeleFlow™ standard ACCOL
load should be an experienced ACCOL programmer. For more information,
consider attending an ACCOL training class. Also see An Introduction to
ACCOL (document# D4056), the ACCOL Workbench User Manual
(document# D4051), and the ACCOL II Reference Manual (document#
D4044).
Universal Operator Interface (UOI) software. Anyone attempting to use the
standard TMS menus must be familiar with the UOI software tools. See the
UOI Configuration Manual (document# D5074) and the UOI Operator
Manual (document# D5075) for details.
EQUIPMENT APPLICATION WARNING
The user should note that a failure of this instrument or system, for whatever
reason, may leave an operating process without protection. Depending upon the
application, this could result in possible damage to property or injury to persons.
It is suggested that the purchaser review the need for additional backup
equipment or provide alternate means of protection such as alarm devices, output
limiting, fail-safe valves, relief valves, emergency shutoffs, emergency switches,
etc. If additional information is required, the purchaser is advised to contact
Bristol Babcock.