Specifications

36
Second step: Select the Motor starter data b
The input and output data of the selected motor starter must be identied within the I/O scanning data.
The Advantys STB conguration tool is used to determine the right offset that ts the starter.
A DDT is associated to the motor starter data type.
This data is used as input and output parameters (Control I/O) of the DFB linked to the motor starters.
This diagram shows the link between a device (starter) connected on STB and the PLC.
Using Advantys congurator we obtain the complete STB I/O mapping. Each I/O module is associated to registers.
After register identications, relevant registers are mapped to the predened structures (DDTs).. Inside the PLC
application the structure is connected to the DFB pin.
QCtrl
STB I/O mapping overview
Starter input data
Starter output data
TeSysU_IO_SCAN_I (DDT)
TeSysU_IO_SCAN_I (DDT)
I/O scan-
ning
PLC Program
Digital input data
Digital output data
Analog input data
Analog output data
Digital input data
Digital output data
FB_Stat
InputOutput
STB Advantys
PLC
TCP / IP
DFB
Direct starter
TeSys-U
conguration
example
4-Conguration
PLC and motor control device conguration
DFB