Daim Ntawv Qhia Tus Neeg Siv
4/6
Getting Online
Once the battery is connected, the internal LED will come on and ash red and the device will do the following:
If the SIM card works and there is sucient charge in the battery, the device will connect to the OEM Server. Go to
www.oemserver.com/installer
(http://www.oemserver.com/installer) and search for the serial number. Conrm that it has
connected recently.
The LED will ash slowly at rst. When it opens a connection to the server, it will ash fast. Once data is sent, it will go
solid briey, and revert to ashing fast. When the device goes to sleep, the LED will switch o.
If the battery is too low, use the harness to provide external power.
If the LED ashes but the Dart does not connect, check the SIM is in the holder correctly and check that the SIM is
working.
Opening and Closing the Housing
The housing closes with clips and does not need screws.
To close the housing, line up the top and bottom parts. Push the housing together rmly.
To open the housing, insert a at screw driver into the opening highlighted below. Carefully lever the two halves
apart.
Getting Started Guide – Dart + Dart2