User manual

CONFIGURATION
001-7100-100 Version 0 Page 56 of 66 Vanguard 3G User Manual CDMA Version
Figure 36 - I/O Settings-Status
The Manager IP address is configured under I/O SettingsÆNMEA SettingsÆ Manager IP address
(see Figure 37).
The port number is 1234 by default and can be customized under I/O SettingsÆNMEA SettingsÆ
Manager IP addressÆ Port.
Note: If Auto is selected for “Manager IP address”, the Vanguard 3G automatically computes the
manager IP address to be Vanguard 3G ETH address +1 if DHCP is disabled. If DHCP is enabled, the
IP address is the starting address offered by the DHCP server.
The unit IP address is the source IP address (displayed in the alarm messages received by the
Manager). The user can configure this to be the Cellular (WAN) Vanguard 3G IP address or the LAN
(Ethernet) Vanguard 3G IP address. If auto is selected, the source IP address is automatically
computed to be Vanguard 3G ETH address +1 if DHCP is disabled. If DHCP is enabled, the IP address
is the starting address offered by the DHCP server.
For each analog diagnostic value displayed, the user can control alarms conditions in the following
ways:
• Set acceptable range of values by entering the low and high thresholds.