User manual

CONFIGURATION
001-7100-100 Version 0 Page 53 of 66 Vanguard 3G User Manual CDMA Version
5.9.4 Remote Delivery
The GPS data can be delivered to up to three remote PCs with UDP viewer programs running on the
host.
Report every: GPS can be programmed to report position after a specified time has elapsed
or the unit has moved a specified distance since its last report.
But no less than: This feature prevents a fast moving vehicle from reporting too frequently
if its “Report every ….. meters” setting is sufficiently low” by setting a minimum amount of
time, in seconds, between GPS reports.
5.10 Serial Port Settings
The following settings allow local or remote GPS reports to be sent out to the user COM port.
Figure 35 – Serial Port Settings
The serial port settings are disabled by default. To enable GPS reports to be sent out to the user
COM port, select “GPS”. The GPS reports could be sent over the serial port “Always” or only “On Loss
of Cellular Signal”.
Note that the following delays apply if the latter is selected:
On power-up
: Reports are delayed for 90 seconds to allow time for cellular connectivity to be
established.
During Operation
: Reports are delayed for 30 seconds after loss of cellular connectivity is
detected.
Select “Local (1 sec)” if every GPS report is required or “Remote (aavl)” for GPS reports to be sent
out based on the AAVL settings (see AAVL settings, section 5.9.4).
Note: GPS Report format is set in the “TCP Server Format” pick lists on the GPS web page.