User manual

CONFIGURATION
001-7100-100 Version 0 Page 42 of 66 Vanguard 3G User Manual CDMA Version
Incoming Port: Enter the port of incoming request. This can be any non-conflicting port
(can be the same as the destination port). This value must be entered following the Vanguard
3G IP address into a browser on a remote PC to access the third party device.
Destination IP Address: IP address of third party device; must be on the same subnet as
the Vanguard 3G radio modem.
Destination Port: Enter the port of the third party device. This will be assigned to the
device by the third party manufacturer and should be in the user manual of the third party
device
IMPORTANT NOTE:
The password protection on the Vanguard 3G product does not protect logging into
a third party device. The third party device must provide its own password
protection (confirm if password protection is required).
Click Add when route configuration is complete. The route will be displayed at the bottom of
the page. Additional routes may be added but require a unique mapping number and port
number. Routes can be deleted (cleared) if no longer needed.
Once the route of the third party device is added you can enter the following on a remote PC
to access the third party device.
http://70.209.115.93:81
Figure 27 - Third Party Device Remote Access Example
“PPP IP Address”
On home page
Note: “http” must be
specified or browser will
assume other
p
rotocols
“Incoming Port”
On NAT Configuation Menu