User manual

CONFIGURATION
001-7100-100 Version 0 Page 34 of 66 Vanguard 3G User Manual CDMA Version
Figure 20 - WiFi (WLAN) Æ Wireless Settings (Client)
Wireless Settings
5.5.2 WiFi (WLAN)ÆWireless Settings (Client)
The user can configure up to 20 access points.
Note: All access points must run a DHCP server.
In wireless client mode, the Vanguard 3G unit will try to connect to the Access Point with the
strongest signal on the list. When the Vanguard 3G unit connects to an access point, it starts a DHCP
client service. The DHCP server running on the access point must provide an IP address, netmask,
and gateway to the Vanguard 3G unit. When the WiFi client is connected to a WiFi access point, the
default route is set to point to the gateway address obtained by the DHCP client.
er: Access point number
f the wireless local area network.
d (Example: Open, Shared, WPANONE,
, TKIP, or AES
y
Access Point Numb
SSID: Service Set Identifier. This is the name o
Channel: Channel number to use (Auto or 1-11)
Authentication: Authentication method to be use
WPA-PSK, WPA2-PSK)
Encryption: None, WEP
WEP Key Length: the bit key length
WEP Key Type: type of WEP security
WEP Key Index: 1-4
Key: The encryption ke