User manual

CONFIGURATION
001-7100-100 Version 0 Page 27 of 66 Vanguard 3G User Manual CDMA Version
Figure 14 - Vanguard 3G Radio Modem Cellular (WAN) Status Page
5.3.2 Activation
Provisioning information (see section 4.6 “Provisioning the Vanguard 3G Radio Modem”.)
5.3.3 Dial Settings
The Dial Settings page allows the user to Disable auto-connect. This page also contains information
on the reconnect timers in the note under the “Connect” selection. These reconnect timers are
defined per carriers certification requirements; they cannot be changed.
By default, the auto-connect feature (labeled “Connect”) is enabled. When this feature is enabled,
the Vanguard 3G radio modem will automatically connect to the network on power up. If the auto-
connect is disabled, you must re-enable the auto-connect, then cycle power or perform a hardware
reset to connect to the network. If you want to keep the auto-connection function disabled, you will
have to disable it before powering down again.
This page also contains dial number, user and password information. This information should only be
entered if required by your carrier.
Note: When establishing a connection to a provider’s network, there are two ways your Vanguard 3G
modem can authenticate and receive its IP address: Mobile IP (MIP) or Simple IP (SIP). Most
providers can allow a MIP-only account, a SIP-only account, or a MIP with SIP fallback account.
On a Mobile IP network, the Vanguard 3G will maintain the same IP address over any geographical
region, while on the SIP network IP addresses may change depending on the geographical location.
If you are using a SIP account, the carrier must provide you with a username and password that
should be entered under Cellular (WAN)ÆDial Settings. If the entries are left blank, the Vanguard 3G
modem will consider itself working with a MIP account.