Operation Manual
Regulatory Information
Human Exposure Compliance Statement Pursuant to 47 CFR § 15.247 (i) of the FCC Rules
and Regulations, personal communications services (PCS) equipment is subject to the
radio frequency radiation exposure requirements specified in § 1.1307(b), § 2.1091 and §
2.1093, as appropriate.
CalAmp Wireless Networks Inc. certifies that it has determined that the STAG04HT &
PTAG04 complies with the RF hazard requirements applicable to broadband PCS
equipment operating under the authority of 47 CFR Part 15, Subpart C of the FCC Rules
and Regulations. This determination is dependent upon installation, operation and use
of the equipment in accordance with all instructions provided.
The STAG04HT & PTAG04is designed for and intended to be used in fixed and mobile
applications. “Fixed” means that the device is physically secured at one location and is
not able to be easily moved to another location. “Mobile” means that the device is
designed to be used in other than fixed locations and generally in such a way that a
separation distance of at least 20 cm is normally maintained between the transmitter’s
antenna and the body of the user or nearby persons. The STAG04HT & PTAG04is not
designed for or intended to be used in mobile applications (within 20 cm of the body of
the user) and such uses are strictly prohibited.
To ensure that the STAG04HT & PTAG04complies with current FCC regulations limiting
both maximum RF output power and human exposure to radio frequency radiation, a
separation distance of at least 20 cm must be maintained between the unit’s antenna
and the body of the user and any nearby persons at all times and in all applications and
uses.
FCC Rules and Industry Canada (IC) regulatory information Compliance Statement (Part
15.19) The equipment device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received including
interference that may cause undesired operation. Warning (Part 15.21) Changes or
modifications not expressly approved by Calamp Wireless Networks could void the
user’s authority to operate the equipment. Manufacturer is not responsible for any radio
or TV interference caused by unauthorized modifications to this equipment. Compliance
Statement (Part 15.105(b)) Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: — Reorient or relocate the
receiving antenna. —Increase the separation between the equipment and receiver. —
Connect the equipment into an outlet on a circuit different from that to which the