User's Manual

5
be maintained between the unit’s antenna and the body of the user and any nearby persons at all times
and in all applications and uses. Additionally, in mobile applications, maximum antenna gain must not
exceed 2 dBi.
FCC Rules and Industry Canada (IC) regulatory information
Labeling Requirements
The SC1204 will have the following listed on a label on the unit:
Contains FCC ID: APV-SC1204
Contains IC: 5843C-SC1204
Compliance Statement (Part 15.19)
The equipment device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received including interference that may cause undesired operation. Warning (Part 15.21)
Changes or modifications not expressly approved by CalAmp Wireless Networks Corp could void the
user’s authority to operate the equipment. Manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this equipment.
Compliance Statement (Part 15.105(b))
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.