User manual

1.3 PHYSICAL DESCRIPTION
Integra-TR consists of a logic PCB (which includes modem circuitry) and a radio module. Each logic PCB and radio module
are matched together and characterized in the factory to optimize performance as an intelligent unit. The two boards then
slide into the rails of an extruded aluminum case.
DTE connection is made via a front panel connector. Power is applied through a rear panel 4-pin connector which includes
two programmable analog connections usable as inputs or outputs.
The unit is not hermetically sealed and should be mounted in a suitable enclosure when dust and/or a corrosive
atmosphere are anticipated. Physically, there are no external switches or adjustments. All operating parameters are set
using the Field Programming Software.
1.4 FRONT PANEL
Integra-TR front panel elements are described in Figure 1 - Integra TR Front Panel Figure 1.
Figure 1 - Integra TR Front Panel
1.4.1 ANTENNA CONNECTOR
Integra-TR antenna connector is a female 50-ohm SMA- type. Units operating with a rubber duck connected directly to the
antenna connector may exhibit unusual operating characteristics and high levels of reverse power.
1.4.2 LED INDICATORS
Integra-TR has four two-color LED indicators. Their functions are shown in Table 1. LED indicators may vary during startup.
Table 1 - LEDs
LED
Color
Functions
RUN/PWR
Green
Normal operation
Flash Yellow and Green Setup mode or loading new application or new bootloader
Flash Red Firmware error (Contact Technical Support)
Red
CPU or PROM failure (Contact Technical Support)
Page | 7