User manual

Random Binary Pattern
Random Binary Pattern is 16 characters in length and contains random binary data.
4.4.11 PING TEST
From the Programmer Window, Select Utilities – Ping Test. The PING Test is used to simulate a Host/Remote polling
environment. The Master sends out a packet to the Remote and the Remote replies to the Master with the same packet
information.
Figure 38: Ping Test
 Remote
Displays the IP Address of the device under test
 Minimum Time
Displays the minimum amount of time taken for the Ping Packet to echo back from the Remote device (in
milliseconds).
 Maximum Time
Displays the maximum amount of time taken for the Ping Packet to echo back from the Remote device (in
milliseconds).
 Average Time
Displays the average amount of time taken for the Ping Packet to echo back from the Remote device (in
milliseconds).
 Blocks Tx’ed to Remote
Displays the number of data packets sent to the Remote device.
 Blocks Rx’ed from Remote
Displays the number of data packets received from the Remote device.
 Ping Quality
Displays the overall percentage of data packets sent vs. data packets received during the Ping Test.
 Type of Data
Displays the type of Data Pattern to be used for each packet.
The size for each Data Pattern is shown below in Packet Size. The following lists the formats of the Data Patterns:
Page | 55