User manual

4.4.10 ARRAY TEST
From the Programmer Window, Select Utilities – Array Test. The Array Test utility is used to send programmable length test
packets. The packets are built using one of four possible patterns. For pattern descriptions, refer to Section XX.
Figure 37: Array Test Screen
 Packets Tx’ed
Shows the total number of data packets transmitted
 # of Packets to Send
Shows the number of data packets to send before stopping (the range is 0 to unlimited)
 Type of Data
Select the data pattern for each data packet. The size and format for each pattern is shown in the pattern
descriptions
 Packet Size
Shows the number of data bytes in each packet
 # of Packets
Shows the number of packets in each transmission
 Packet Delay
Shows the amount of time (in seconds) to delay between each packet transmission (range is from
0.00 to 30.00 seconds in 0.25 second intervals).
 COM Port
Select Primary or Secondary COM Port to be used for transmitting data.
Page | 53