User manual
RevP
Reverse Power displays the approximate measure of reverse (reflected) power of the unit transmitting the
diagnostics. This is represented as “Good” if the reverse power is within acceptable limits and is represented as
“Bad” if the reverse power is too high. The threshold is set to approximately 1/4 the forward power.
Remote RSSI
If these are the diagnostics from a Remote Station, Remote RSSI indicates the RSSI level of the Remote Station
from the last received transmission. If these are diagnostics from the Local Station, Remote RSSI indicates the RSSI
level of the Remote Station last received at the local Station.
Rx Quality
Displays the receive quality (in %) of the remote unit. This is the number of correctly decoded transmissions
received (in the last 15) divided by the number of total transmissions detected.
Time
The time stamp when the diagnostics were received.
Filter
Allows the user to filter Short IDs. The following options are available:
• Off (All IDs): no IDs are filtered out.
• ID List: only the IDs in the Filter ID List are shown.
• Selected ID: only the selected ID in the Filter ID List is shown.
Display
Allows the user to format on screen data. The following options are available:
• Scroll (by time): displays the diagnostics as they are received.
• Slotted (by ID): sorts the diagnostics by Short ID. Using this option, each Short ID will have one row of
diagnostics, showing the most recent.
Progress
This panel shows the sorting progress of the diagnostics if a filter was changed.
Local ID
The Short ID of the unit interfaced with the PC.
Filter ID List
This is a listing of Remote IDs setup in the Diagnostic IDs and Alarms Screen. This list is used for selecting a filter.
Pause
Allows the user to pause the reception of the diagnostics for scrolling through the grid.
Clear
Allows the user to clear the display and current Online Diagnostics.
Save
Allows the user to save the current Online Diagnostics to a file. A maximum of 4096 lines of data can be saved.
Page | 47