User manual

4.4.1 PORT SETTINGS
From the Programmer Window, Select Utilities – Port Settings
Integra-TR programming is done through the PC’s Primary COM Port. Primary and secondary COM ports are configured with
the Field Programming Software. The programming cable (included in the Programming Kit - DRL part number 250-4008-
001) is connected from the Setup Port on the Integra-TR to the PC’s COM port configured as the Primary Port. The Port
Settings screen of the Field Programming Software is accessed via the Utilities pull-down menu.
The Port Settings screens are used to configure the PC’s serial COM Ports. COM Port parameters are defined in 2.4.2.1.
COM Port assignments are displayed in the bottom status bar of the Integra-TR Field Programming Software screen.
Figure 28 – COM Port Settings Screen
4.4.1.1 PRIMARY/SECONDARY COM PORT PARAMETERS
 COM Port
Select COM 1-32 to identify the Port number to be used for the Primary and Secondary COM ports
 Baud Rate
Select 1200, 2400, 4800, 9600, 19200, 38400 or 115200 to set the communication speed for Primary and
Secondary COM Ports
 Data Bits
Select 7 or 8 for the number of data bits transmitted or received for the Primary and Secondary COM Ports
 Parity
Select Even, Odd, or None for the transmission or reception of any Parity Bits for the Primary and Secondary COM
Ports
Page | 36