User manual

The frequencies for these splinter channels are:
154.456250
154.463750
154.471250
154.478750
173.203750
173.237500
173.262500
173.287500
173.312500
173.337500
173.362500
173.396250
Tx Power
This field designates the channel pair Power Output Adjust value. The default value is 255 (5 watts). This value
should be left at the default value unless lower power is required to meet regulatory requirements, to increase the
allowable transmit duty cycle or to reduce transmit power. As the output is adjusted downward (less RF output
power) the overall current requirements of the Integra are lessened. When optimizing a system for operational
parameters such as RF coverage and over all power (current) usage, the correct amount of RF power needed for
coverage may actually be less than full (5 watts) output. This in turn can lower overall power (current) needs of the
wireless modem. NOTE: Power does not vary linearly with this parameter so some experimentation may be
required to determine the correct power setting.
4.3.2 VERSION REQUEST
From the Programmer Window, Select Edit – Version Reset to display the following information about the connected
device.
Integra-TR: displays the Modem Firmware Version Number)
Serial Number: displays the serial number of the modem module
Short ID: displays the Short ID of the connected device. Refer to Section XX to program the Short ID.
Comment: displays the comment field for the connected device. Refer to Section XX to enter a user comment.
Board Rev: Displays the board revision number of the connected device.
Figure 22: Version Request Screen
Page | 32