User manual

4.3.1 SETUP MODEM/RADIO PARAMETERS
To access the Setup Modem/Radio Parameters screen, use the Parms Icon. You may also access this screen from the Edit
menu.
Setup Modem/Radio Parameters allows the user to view and edit Integra-TR’s programmable parameters. Programming
parameters can be stored in a data file with the .DAT file extension. Programmable parameters are used by the
Read/Program Parameters screen for programming into nonvolatile memory (see This section describes the Modem
Operating Parameters shown in Figure 15.
Figure 16).
Parameter settings are modified from four screen tabs: the Modem tab, Com/Analog tab, Radio tab and Frequencies tab.
Once the desired parameters have been entered for each window, select OK to store the parameter information into local
PC memory or select Cancel to exit the Set up screen without making any modifications to the currently stored parameter
file.
4.3.1.1 SET UP MODEM/RADIO PARAMETERS: M
ODEM TAB
This section describes the Modem Operating Parameters shown in Figure 15.
Figure 16: Setup Modem/Radio Parameters – Modem Tab
 Modem Type
Displays the Modem type of the connected device
 Board Rev
Displays the hardware revision number of the modem board in the connected device
Page | 23