User manual

Figure 7 - Point-to-Point System
3.2.2 POINT-TO-MULTIPOINT SYSTEM
A basic point-to-multipoint system is shown in Figure XX.
Figure 8 - Point-to-Multipoint System (simplex or half-duplex)
If a half-duplex radio network is used (i.e. two frequencies with the master station transmitting and receiving on the reverse
pair from the remotes), the master station can be either full duplex or half-duplex.
If a simplex radio network is used (i.e. a single frequency for all stations), we recommend that the master Integra-TR be set
to “master”, the remotes to “remote” and all units to “selective” data delivery. This will prevent remote stations from
hearing each other's responses. For full duplex configuration, set the receiving unit Rx/Tx Mode to Rx Only (using the Field
Programming Software). Set the transmitting unit mode to Tx Only.
Figure 9 - Point-to-Multipoint System (full-duplex)
Page | 18