User manual

Approvals/Certifications UHF
FCC IDENTIFIER
NP44048350 9K30F1D, 15K3F1D
IC IDENTIFIER 773B-4048350 9K30F1D, 15K3F1D
FCC IDENTIFIER NP44048351 3K30F1D, 3K40F1D, 8K80F1D
FCC IDENTIFIER NP44048551 3K30F1D, 3K40F1D, 8K80F1D
IC IDENTIFIER
773B-4048351 3K30F1D, 3K40F1D, 8K80F1D
IC IDENTIFIER 773B-4048551 3K30F1D, 3K40F1D, 8K80F1D
2 GETTING STARTED
It is easy to set up an Integra-TR network to verify basic unit operation and experiment with network designs and
configurations. An RX/TX antenna is required for basic operation. It is important to use attenuation between all demo units
to reduce the amount of signal strength in the test environment.
2.1 DEVICE CONNECTIONS
Refer to the diagram below for the proper device connections for basic operation.
2.2 FIELD PROGRAMMING SOFTWARE
The Integra-TR Field Programming Software (FPS) is the programming and diagnostics software for the Integra-TR wireless
modem. The software allows the user to edit and program user programmable settings, interactively tune modem and RF
parameters, and monitor diagnostic data from the Integra-TR.
There are two specific model categories. The 2424048X50 models are the 12.5/25.0 kHz models and the 2424048X51 are
the 12.5/6.25 kHz models. The models are set up at the factory. The model specific parameters are grayed out in the Field
Programming Software and cannot be changed outside of the factory.
Page | 14