User manual

001-5099-000 HiPR-900 User Manual
75
Figure 82 - Neighbor Table
Item Description
Unit ID Displays a neighboring unit's RF MAC address and name.
Unit Configuration
RF IP Address: displays a neighboring unit's RF IP address and net-
mask.
Ethernet IP Address: displays a neighboring unit's Ethernet IP address
and netmask.
Route
#: Indicates whether the route is primary [pri] or backup [bkp]
The neighbor discovery algorithm keeps information about two best
paths to any neighboring unit. The primary path is used (by default)
when building the internal routes. Use Toggle function to manually
switch to the backup path.
Next Hop: Indicates the ID of the unit that's next on the path to the
neighboring unit. (If the neighboring unit is only 1-hop away the field
indicates the ID of the neighboring unit itself)
Hop Count: Indicates the number of RF hops from the unit to the neigh-
bor. 1-hop neighbor is a neighbor that a unit can talk directly to: both
units are in the same RF coverage area. 2 and more hop neighbors are
neighbors that cannot be reached directly.
Status: Indicates if the route is active or inactive.
Toggle: Switches between primary and backup route. The toggle
switching can take up to 1500 ms to take effect and if the backup path
is the desired path, the path should be locked (see section 6.7.7)
Status
Displays the unit's status:
Unit's Operating mode: Master, Repeater or Remote
Relay Point (RP) if enabled
NAT if enabled
Access Point (AP) if enabled
Proxy if TCP is enabled
Static if neighbor entry was defined by the user, Dynamic if the entry
was acquired by the neighbor discovery module
Del
Deletes the neighboring unit from the Neighbor Table. If the unit still
exists in the RF network, the neighbor discovery module will find it. To
see it appear in the Neighbor Table the user may press Refresh List
button, allowing sufficient time for the neighbor discovery module to
locate the unit.
Poll
Polls the unit. Used to test if a unit is reachable.
Poll All
Polls all units in the Neighbor Table.
Clear List
Clears the Neighbor Table. Deletes all entries.
Refresh List
Refreshes the Neighbor Table. Note that this page does not refresh
automatically