User manual

001-5099-000 HiPR-900 User Manual

6.7.6.2 Unit Configuration Control

Important note: Record all original HiPR-900 factory settings for possible future use.

Figure 75 - Maintenance - Unit Configuration Control (Initial screen)

Item Description

Active Configuration Description

Active Configuration Description Field – available by selecting “Check-

point User Configuration” radio button in the “User Configuration Set-

tings “portion of this window below.

User Configuration Settings

Checkpoint User Configuration (Save User Configuration) – saves a set

of the current user configuration settings in the HiPR-900.

Click on the “Checkpoint User Configuration” radio button to activate

the “Active Configuration Description” field. Enter a descriptive title of

up to 40 characters to help identify the configuration settings to be

saved. Click on “Proceed” to save the settings to the unit. The new con-

figuration set overwrites the factory (or previously user saved) configu-

ration settings.

Restore User Configuration Checkpoint (Load User Configuration) – the

radio button is available if “User Configuration Settings” have been

previously saved. To restore to user configuration, click the “Restore

User Configuration” radio button. Check the title of the settings about

to be restored in the “Active Configuration Description” field and click

on “Proceed” to restore the settings to the unit.

Firmware Upgrade Settings

Merge settings bundled in upgrade package with current configuration-

merges upgraded settings with the current configuration.

Note: the "firmware update" process will end up replacing an existing

configuration file with the one that came bundled with the firmware

upgrade package.

Factory Settings

Restore Factory Settings: restores all settings to default factory confi-

guration.

Upon performing the firmware upgrade, should you decide to restore to

factory settings instead of to “merge with bundled settings”, simply

select the “Restore Factory Settings’ radio button right after performing

the firmware upgrade and click on “Proceed”.

Important note:

Activating “ Restore Factory Settings” will reset the IP address of the

unit. Have your record of all the original HiPR-900 factory settings han-

dy before proceeding with restoring to factory settings.