User manual

001-5099-000 HiPR-900 User Manual
61
6.7.3.5 IP Optimization & Tuning
Figure 63 - Advanced IP Configuration – IP Optimization & Tuning (Router Mode)
Item Description
RF ACK Disabled (Default), Enabled
OIP Retries Number of OIP retries (for non TCP traffic like ICMP). Default = 1
Note: No optimizations are available in Bridge Mode. Figure 63 shows Router mode screen.
6.7.3.6 IP Routing (exclusive to the full-featured HiPR90 version)
Figure 64 - Advanced IP Configuration – IP Routing
Item Description
IP Routing Table Displays the table of IP routes that are active in the HiPR-900.
Destination IP address of the route
Netmask Netmask of the route
Gateway Gateway of the route (next hop)
Type
Static routes: User-defined routes.
Dynamic routes: Routes learnt by the HiPR unit with RIPv2 protocol.
(RIPV2 must be enabled in Setup (Advanced) → IP Services)
Direct routes describe addresses that are directly reachable (1 hop
away).
Indirect routes describe addresses that cannot be reached directly (i.e.
addresses that are more than one hop away).
Add/Delete
Allow the user to add or remove routes manually to/from the table.
Warning: Manipulate this table with caution!