User manual

001-5099-000 HiPR-900 User Manual
29
Item(cont’d)
Description
Sync Status For remote and repeater units - Displays unit sync status in relation to Master
Temperature Displays unit’s internal temperature
Power Source Indicates voltage input used: “Power over Ethernet “or “DC input”
H/W Status
Summary report of hardware error checking at Power ON self-test. Works in conjunc-
tion with the front panel Power LED (flashing red). Displayed sentence always starts
with “HW failure…”. Unit will reset (as if power was cycled) 5 minutes after a self-test
error is detected.
Summary report of driver error detection. Works in conjunction with the front panel
Power LED (flashing green). Unit will not reset.
For both types of reports, have the displayed H/W Status message (or combination of
messages) handy if contacting Dataradio support. Also required if returning unit for
service under RMA.
Homologation
Factory-set. Shows the territory the unit has been configured for operation and ap-
proved by the appropriate governmental authority.
Informational display: North America, New Zealand, or Australia
Clear H/W Status
Button allowing user to acknowledge and clear errors.
Errors remain stored, even after cycling power, to aid in troubleshooting intermittent
faults. Press the “Clear H/W Status” button to return web page displays and Power LED
function to normal operation.
Flash Power LED
Button allowing user to assure that he/she is setting up the correct unit.
Press “Flash Power LED” button to see the power LED flash on this unit for 30
seconds.
6.7.2 Setup (Basic)
6.7.2.1 Setup (General)
Figure 30 - Setup (Basic) General -full-featured HiPR-900 (left), HiPR-900S (right)
[phone] [e-mail] www.dataradio.ru
ООО "ДатаРадио" - официальный представитель в Роcсии