User manual
001-5099-000 HiPR-900 User Manual
21
6.3.4 IP Network Settings in Router Mode (with Router)
(Exclusive to the full-featured HiPR-900 version)
Referring to Figure 17, set one of the HiPR-900 as a Master. Set the Router mode on all units. Set the
Eth1 IP addresses and IP netmask of both Master and Remote.
Keep the RF IP setting as is if not using the 10.0.0.0 IP network on your Intranet.
Enable the Dynamic Registration on both Master and Remote.
Add Default Gateway to the RTU
Enable RIPv2 on Master
In the illustration, Host and RTU are part of different IP subnet.
Figure 17 - IP Network Settings in Router Mode (with Router)
6.3.5 IP Network Settings in a Network with Repeater Unit
(Exclusive to the full-featured HiPR-900 version)
In router mode of operation, the RF network must be seen as a single IP network. All RF IP interfaces of
all units must be part of the same IP network. All Ethernet IP interface of all units must be part of a dis-
tinct IP network (unless NAT is enabled).
Figure 18 - IP Network Settings in Router Mode (with Repeater)
HiPR-900 Master
Dynamic Registration
RIPv2 / DHCP Server
Eth1 IP: 172.30.1.2
MA
S
K: 2
55
.2
55
.2
55
.
0
RF IP: 10.x.y.z
MASK: 255.0.0.0
HiPR-900 Remote
Dynamic Registration
DHCP Server
RF IP: 10.a.b.c
MASK: 255.0.0.0
Eth1 IP: 172.30.2.1
MA
S
K: 2
55
.2
55
.2
55
.
0
RF Network
Router (RIPv2)
IP: 172.30.1.1
MASK: 255.255.255.0
RTU
IP: 172.30.2.2
MASK: 255.255.255.0
Default Gateway: 172.30.2.1
Host
HiPR-900 Master
Dynamic Registration
Eth 1 IP: 172 .30 .1.2
MASK : 255 .255 .255 .0
RF IP : 10.
x
.y.z
MASK : 255.0.0.0
HiPR-900 Repeater
Dynamic Registration
RF IP : 10.a.b.c
MASK : 255.0.0.0
Eth 1 IP: 172 .30 .2.1
MASK : 255 .255 .255 .0
Host
RTU
IP: 172 .30 .2.2
MASK : 255 .255 .255 .0
Default Gateway : 172 .30 .2.1
MASK : 255 .255 .255 .0
IP : 172 .30 .1.1
HiPR-900 Remote
Dynamic Registration
RF IP : 10.d.e .f
MASK : 255.0.0.0
Eth 1 IP: 172 .30 .3.1
MASK : 255 .255 .255 .0
RTU
IP : 172 .30 .3.2
MASK : 255 .255 .255 .0
Default Gateway : 172 .30 .3.1
Route add 10.0.0.0 mask 255 .0.0.0 172 .30 .1.2
Route add 172 .30 .2.0 mask 255 .255 .255 .0 172 .30 .1.2
Route add 172 .30 .3.0 mask 255 .255 .255 .0 172 .30 .1.2