User manual

001-5099-000 HiPR-900 User Manual

6. Operation & Configuration

Instructions and examples given in this manual are based on HiPR-900 operating software version at the

time of writing this document and may not apply to earlier or later software versions. Screen captures

used throughout this document may vary from actual screens.

6.1 LAN Setup

Check that DC power is applied to the HiPR-900 radio modem (PoE or PWR input). On a PC running

MS-Windows with an existing LAN connection, connect to the RJ-45 input of the HiPR-900. Set-up PC

as follows:

1. Click Start Î Control Panel Î Network Connections

2. Click on the relevant Local Area Connection

3. On the Local Area Connection Status screen, click Properties

4. On the Local Area Connection Properties screen, scroll the List Box until “Internet Protocol

(TCP/IP)” is highlighted, click Properties

5. On the Internet Protocol (TCP/IP) Properties screen, follow either method below:

A) Select “Obtain an IP address automatically”

B) Select “Use the following IP address” Î Enter 192.168.204.254 in the IP address field Î

255.255.255.0 in the Subnet mask ÎLeave the Default gateway blank.

6. Click the OK button

Note: Certain Operating Systems require rebooting to complete the connection process.

6.2 Default IP Settings

• Default Operating mode is Remote

• Default IP Forwarding mode is Bridge

• Time Division Duplex (TDD) RF protocol is enabled by default

6.2.1 Ethernet Interface

• MAC: 00:0A:99:XX:YY:ZZ

• IP ADDR: 192.168.204.1

• NETMASK: 255.255.255.0

• Default Gateway: 0.0.0.0

• DHCP Server Enabled

6.2.2 RF Interface

• MAC: 00:XX:YY:ZZ

• IP ADDR: 10.XX.YY.ZZ

• NETMASK: 255.0.0.0

• TCP Proxy Disabled