Specifications

11 SETUP AND DIAGNOSTIC UTILITIES

In order to set up the EtherMeter, the technician should actuate the #1 dip switch to the “up”

position. At this point, industrial protocols are disabled on the active serial port (RS-232 or RS-

485, depending upon the #2 dip switch). In setup mode, the serial port operates with the

following parameters:

8 data bits, 1 start bit, 1 stop bit, no parity, no flow control.

The technician should press the <ENTER> key to refresh the screen.

Note that, from any screen, <ENTER> causes a refresh, and <TAB> causes the display to

proceed to the next screen. There are nine (9) setup screens in total.

For reference, the nine (9) Setup Menu screens are shown below:

Setup Screen #1 of 9

“Meter Setup”