User manual

120 20131-301 Gemini G3 – User Manual
vii
Rectifies typo on Figure 22 - Basic NAT Operations
Rectifies caption and adds NPSPAC values to Table 1 - On-Air Data Speeds &
Modulation
Updates screen capture for Figure 21 - Advanced IP Configuration –
IP Services Setup
Updates screen capture for Figure 44 - Advanced IP Configuration -
Ethernet (PHY)
Updates section 4.7.2.3
Updates section 4.7.3.5
Updates section 4.7.3.6
Updates section 4.7.3.9
Updates section 4.7.7.2
Updates section 4.7.7.4
Adds NPSPAC values to Table 6 - Carrier Deviations
Updates Section 6, Specifications with NPSPAC values
Adds Appendix 1 - "Officer Requires Assistance" alarm function
Adds Appendix 2 - "GPS Data Collection" Instructions
Adds Appendix 3 - E-DBA Throughput/Latency Measurements Methods
Adds Appendix 4 - Time Synchronisation, and WEB Browser Cache - Instructions
Adds Appendix 5 - Ethernet Configuration - Recommendation
Version 2.01, October 2006
Updates Definition pages
Updates screen capture for Figure 16 - Setup (Basic) – Serial Ports Setup
Updates Table 5 - Test Checklist
Adds Table 6 - Carrier Deviations
Revises RX sensitivity in Section 6 “Specifications”
Version 2.00, September 2006
Initial release of common version of Dataradio GeminiG3 UHF / 700 /
800 MHz mobile data radiomodem User Manual.
Version 1.01a, April 2006
Change of descriptive terminology from a specific “type of
connection” and “type of crimping equipment” to “type of connection
present on radiomodem” in the following Sections:
- 2.5.1 “Recommended tools and supplies
- 2.5.3 “Antenna Installation” steps 3, 4, and 5
- 3.1 “Front & Rear Panels” listing
- 5.1 “Equipment Required” for Trouble-Shooting and Testing
Revision of terminology in Section 6 “Specifications” for Re-
ceiver “Sensitivity” entry.