Specifications

DiscreteI/O
Page|45

c) ControlOutput–Thisisthedefaultsetting.Thediscreteinputcanbeusedtocontrolthediscreteoutput.
Refertothenextcontrol(OutputWillBe)formoreinformation.

d) SendUDPPacket–ThemodemcanbeconfiguredtosendaUDPpacketperiodically
and/orwheneverthe
inputstatuschanges.ThepacketincludesthemodemESN(orIMEI)andthecurrentstatusoftheinputand
theoutput.

 DiscreteOutputWillBe:
Thisfieldisenabledonlyif“ControlOutput”isselectedforInputFunction.

a) SameasInput–Whenselected,the
outputdiscretewillbedrivenbythemodemtothesamestateas
currentlysensedfortheinputdiscrete.Debounceoftheinputdiscretewilldelayachangeintheoutput
discretebyapproximately1second.

b) OppositeofInput‐Whenselected,theoutputdiscretewillbedrivenbythe
modemtotheoppositestateas
currentlysensedfortheinputdiscrete.Debounceoftheinputdiscretewilldelayachangeintheoutput
discretebyapproximately1second.

 UDPSendIPAddress:
Thisfieldisenabledonlyif“SendUDPPacket”hasbeenselectedfor“InputFunction”.Enter
avisibleIPaddress
heretoreceiveperiodicandonchangenotificationsofDiscreteI/Ostatus.Theformatofthenotificationis
discussedbelowunder“UDPNotificationFormat”.

 DestinationPort:
Thisfieldisenabledonlyif“SendUDPPacket”hasbeenselectedfor“InputFunction”.Entertheportnumber
at
theaboveIPAddressthatisreadytoreceivethenotifications.Makesurethereceiver’sfirewallissetappropriately
toallowtheUDPpackettoreachthespecifiedport.

 OnChange,andEvery:
Thisfieldisenabledonlyif“SendUDPPacket”hasbeenselectedfor“InputFunction”,
oroneoftheoptionsfor
“SendSMS”hasbeenchosen.Enterthetimeinminutesforwhichaperiodicstatusupdateisdesired.If
notificationisonlywantedwhentheinputchangesstatus,enter“0”inthisfield.Beawarethatyourcarrier’stext
messageratesmayapplyfor
eachmessageinitiatedbythemodem.
SMSoptionsareonlyavailableon882‐GPRSand882‐EDGEmodems.
 SendSMS:
Thisfieldisenabledonlyifeither“SendUDPPacket”or“ControlOutput”havebeenselectedfor“InputFunction”.
Chooseunderwhatconditionsashort(text)messagetothespecified
destinationMDN.Amessagecanbesent
whentheinputchangesto“Ground”,and/orwhentheinputchangesto“NotGround”.Beawarethatyour
carrier’stextmessageratesmayapplyforeachmessageinitiatedbythemodem.

 SMSDestinationMDN:
Thisfieldisenabledonlyifa“Send
SMS”optionhasbeenchecked.Specifythe10digitMDNanSMSmessageisto
besentto.Caution–EnteringanincorrectMDNmaycauseaSMStobeundeliverable,ordeliveredtoan
unsuspectingparty.CarrierchargesmaystillapplytoawronglyaddressedSMS.