User manual

001-0003-822 Rev 1
Page 14 of 48
been provisioned. The modem must first be provisioned with the specific carrier before connecting
with the cellular network.
Provisioning
In order to use the modem, it must be activated by the specific carrier once the ESN has been
provided for the account. Over-The-Air (OTA) activation is supported and each carrier has a different
procedure. Refer to Sections 5 and 6 for information on provisioning for specific carriers.
Modem Network Connection
After the modem has been successfully provisioned, the cellular data connection can be enabled. At
the Home page, select “Data Connection” from the side menu bar. Fill out the Dial Number, User,
and Password fields required for the specific carrier account. The default values for Verizon and
Sprint are shown in Figure 4.5, a dial number of atd#777 and blank username and password.
Select “Enable” on the Auto Connect line and then click the Save button.
Figure 4.5: Data Connection configuration page
The DCD LED on the front panel will light when a connection to the cellular network has been
established. Go back to the Home page to verify the PPP Status is UP (Figure 4.6). The PPP IP
Address field shows the current IP address the network has assigned the 822-1XRT/882-EVDO
device as well as other PPP parameters.