Installation Manual

Product Configuration
Plug in the AC adapter to the outlet and connect to the Ecco repeater. Turn on
the device by pressing the “Power” button. Consult the table below to identify the
appropriate signal band (“A”, “B”, “C”, “D”, “E”, or “F”) for your Sprint PCS
market.
Now select the appropriate PCS signal band on the Ecco by pressing the “Band
Select” button until the desired band is lit up in the “Current Band” display. At
this time, the product is in installation mode and the “Current Band” display will
be flashing. Wait approximately 10 seconds, then briefly turn the unit off and
back on with the power button. The “Current Band” display should now be solid
(not flashing) and the Ecco is now fully operational.
Battery Backup
The Ecco is normally powered by the included 6V DC plug-in power supply. It
also facilitates six (6) standard AA alkaline batteries in the compartment on the
side that serve as backup in case of power failure. Under battery power, the
device will run for approximately 15 minutes.
Troubleshooting
Still having trouble?
9 Is the LED display of the Ecco facing indoors and away from the window?
9 Is the appropriate signal band (“A”, “B”, “C”, “D”, “E”, or “F”) for your Sprint
PCS market shown in the “Current Band” display?
9 Is the “Current Band” display lit solid (not flashing)?
Insert US map with applicable frequency bands