User's Manual

001-2019-500 Rev 0 Paragon4 – UHF, 700 & 800MHz User Manual
18
6. Operation & Configuration
Instructions and examples given in this manual are based on E-DBA operating software version current at
the time of writing this document and may not apply to earlier or later software versions. Screen captures
used throughout this document may vary from actual screens.
6.1 Browser-Based Interface
A built-in web server makes configuration and status monitoring possible from any browser-equipped
computer, either locally or remotely. Status, configuration, and online help are available without requiring
special client software. Setup is password-protected to avoid tampering or unauthorized changes.
Both the configuration parameters and operating firmware can be updated remotely, even over the RF
network itself, using the standard File Transfer Protocol (FTP).
Figure 10 - Web Interface
6.1.1 Interface Setup and Status
The Paragon4 user interface is used to view and configure your network settings. Figure 10 shows the
welcome screen of the Web Interface. The screen is subdivided in two frames: the frame on the left al-
lows the user to navigate through the menus, while the main frame on the right displays the selected page.
The menu system is two-leveled; some of the top-level menus expand to offer submenus. The Site Map
link can be found right below the menus on the navigator pane. Help is available for each page displayed
in the main frame. It can be accessed at all times by clicking the Help icon. The remaining buttons on the
bottom of the Navigator frame are used to save your configurations and reset the unit.
Navigator
Frame
Main
Frame
Preliminary