User's Manual

001-2019-500 Rev 0 Paragon4 – UHF, 700 & 800MHz User Manual
95
4. Once the file transfer is complete, cycle the base power and allow the unit to boot. The
unit should return to the state it was in when the update was started.
Note:
After resetting, the PWR LED remaining lit steady amber or red indicates the FTP trans-
fer was not successful or that the firmware is corrupt. Please contact Dataradio system
engineering for assistance.
Figure 79 - Sample FTP program
5. Verify the integrity of the newly transferred files.
a) Connect to the base’s IP address using an Internet browser
b) Enter the user name and password (in the usual manner) and allow the Welcome
page to load.
c) In the left pane, click on Unit Status. The Unit Identification and Status pane should
display the newly upgraded firmware in its Banner (should correspond to the upgrade pack-
age version) and the H/W Status should also show Ok.
d) In the left pane, click on Maintenance, then on Package Control. Wait a few moments
for the results to display.
7.5.1.1 File Integrity Failure
If the message in the result screen points out that file(s) failed the integrity check, retry the FTP
transfer for the failed files(s) again.
If the problem persists, please have the Package Control result screen indications handy and
contact Dataradio system engineering for assistance.
Preliminary