User's Manual

120 20194-102 Paragon3 – 700/800MHz User Manual
5
7
6.1.3 Channel Selection via DIP Switches
The backplane-mounted DIP switch settings override the default channel programmed by PGM800Win.
To set a default channel via the software, all DIP switches must be set to “OFF” (i.e. 0000).
When a switch is “Off”, its binary count is active; when a switch is “ON” its binary count is inactive. The
various DIP switch combinations of ON or OFF make up a binary total, which identifies the channel num-
ber.
To select a channel, set the appropriate DIP switch or switches to “OFF” to make the binary count total the
channel number you want. Set all other switches to “ON”.
Example: To select channel 5, set the DIP switches as shown below:
Figure 50 – Backplane DIP switches example – Channel 5 selected
1
2
4
“ON” required: default channel follow-
ing the binary count
CHANNEL SWITCH TX
1
2
3
4
O
N
Binary
Value