User's Manual

120 20194-102 Paragon3 – 700/800MHz User Manual

4.7.2.3 Setup (Basic) ► Serial Ports Setup

The Paragon3 base station serial ports can be logically connected to local and remote services to aid in

configuration and troubleshooting, or they can be connected to a remote Host application or even to the

serial port of a remote unit.

Figure 24 - Setup (Basic) – Serial Ports Setup

Item Description

Enabled Independent check boxes to activate COM-1 PORT and/or COM-2 PORT

Speed Select 300, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 Baud Rate

Flow Control Select None or CTS-based (RTU dependent)

Connection Control Select Permanent (3-wire) or Switched (DTR bringup/teardown) (RTU dependent)

IP Gateway Service

Select one of:

CLI Service (Command line interface) RS-232 connection to Host PC (Default = SETUP)

Custom – Choosing Custom enables the IP Gateway Transport configuration

IP Gateway Transport

Available only if IP Gateway Service selection is Custom, choose the socket connection mode

from the drop-down list box choices of TCP Server, TCP Client, or UDP.

Local IP Address

Valid unicast or multicast IP address, including the local Loopback interface address.

Default local IP address is set to 0.0.0.0 and can be changed dynamically without a unit reset.

Local IP Port

For TCP Client and UDP socket connections, set to any value between 1 and 65535.

For TCP Server socket connections, set to any value between 1 and 65535 but must not be set to

one of the following values or fall within the following ranges of values: 20, 21, 23, 123, 520, 5002,

6254 to 6299, 7000 to 7100. Otherwise, the parameter configuration will be accepted, but no

socket connection will be established to accept connection from remote endpoints.

Default local port value is set to 1024 and can be changed dynamically without a unit reset.

Remote IP Address

Default remote IP address is the Loopback interface address, 127.0.0.1 and can be changed dy-

namically without a unit reset

Remote IP Port

For socket connection modes (TCP active, UDP), set to any value between 1 and 65535.

Default local port value is 23 and can be changed dynamically.

10.255.255.255