Manualshelf

User's Manual

ManualsBrandsCALAMP WIRELESS NETWORKS ManualsElectronics70W Power Amplifier CRE 700
31323334353637383940
120 20194-102 Paragon3 – 700/800MHz User Manual
2
6
4.7.3 Setup (Advanced)
4.7.3.1 Setup (Advanced) ► LAN (IP)
Allows the setting of IP characteristics beyond those set in “Setup (Basic)” Î “Basic IP”.
When a mobile registers with a new base, the base may send a message to each of its neighbor to
assure that their Internet tables are up-to-date. Up to 32 neighbors can be entered. An empty or
incomplete table may cause IP routing problems when the mobile roams.
Figure 25 - Advanced IP Configuration - LAN (IP)
Item Description
IP Address
Netmask
Read-only fields showing “IP Address” and “Netmask address” defined earlier in
“Setup (Basic)” Î “Basic IP”.
MTU
Ethernet Interface MTU - Default 1500. – For optimal performance, set at 1500.
Entering a value lower than 1500 may reduce system performance. Flexibility of us-
ing lower values may be useful in testing or for particular operational conditions.
Range is 576 to 1500.
Interface 1 (ETH1)
MAC address Ethernet Interface MAC address in HEX format (factory-set).
IP Address
Set to valid unique IP address for each individual unit.
Factory default is 192.168.203.1 for all Paragon3 units connected to their ETH2 port.
For ETH1 configuration, see Setup Basic Î Basic IP Configuration
Netmask
Set to valid IP netmask for each individual unit (may be same or different depending
on customer’s IP network topology).
MTU
Ethernet Interface MTU - Default 1500. – For optimal performance, set at 1500.
Entering a value lower than 1500 may reduce system performance. Flexibility of us-
ing lower values may be useful in testing or for particular operational conditions.
Range is 576 to 1500.
Interface 2
(ETH2)
MAC address Ethernet Interface MAC address in HEX format (factory-set).
Add
Type in the “Neighboring Bases” field the IP address in dot decimal format of the
base to be added to the neighboring “Base List” table.
Delete
Type in the “Neighboring Bases” field the IP address in dot decimal format of the
base to be deleted from the neighboring “Base List” table.
Neighboring
Bases
Base List
Read-only listing. Dynamic window expands downward as needed to show all ad-
dresses added to the list or shrinks as addresses are removed.