User's Manual
Table Of Contents
- 1 VIPER OVERVIEW
- 2 SYSTEM ARCHITECTURE AND NETWORK PLANNING
- 3 DATARADIO VIPER QUICK START
- 4 VIPER WEB MANAGEMENT
- 5 UNIT STATUS
- 6 SETUP (BASIC)
- 7 SETUP (ADVANCED)
- 7.1 RF OPTIMIZATIONS
- 7.2 IP SERVICES
- 7.3 IP ADDRESSING
- 7.4 IP OPTIMIZATION
- 7.5 IP ROUTING (TABLE/ENTRIES)
- 7.6 TIME SOURCE
- 7.7 ALARM REPORTING
- 7.8 USER SETTINGS
- 8 SECURITY
- 9 STATISTICS
- 10 MAINTENANCE
- 11 NEIGHBOR MANAGEMENT
- 12 NETWORK OPTIMIZATION
- 13 UPGRADING YOUR FIRMWARE
- VIPER SPECIFICATIONS
- PRODUCT WARRANTY
- DEFINITIONS
Viper. Select the configuration file to load and click on "Proceed". Click "Save Config" then
"Reset Unit" to complete the process and store these settings to the unit.
Firmware Upgrade Settings
ton and click
are upgrade" process will replace the Viper existing configuration with the
rmware bundled with the upgrade package.
imply select the "Restore Factory
ettings" radio button and click "Proceed". Click "Save Config" then "Reset Unit" to
ess.
ating "Restore Factory Settings" will reset the IP address of the unit.
eview your record of the original Viper factory settings before proceeding with the Restore
0.3 PACKAGE CONTROL
upgrade of the Viper radio
odem firmware. If the installation was successful, the web page will indicate "Pass". If
unsuccessful, the web page will indicate "Fail" and an error message will
an upgrade problem arises, click the "Package Control" once more and have the results
he Package Validation window is for reference only. No user configuration is available on
Merge settings bundled in upgrade package with current configuration - merges upgraded
settings with the current configuration. Select the "Merge Settings..." radio but
"Proceed". Click "Save Config" then "Reset Unit" to complete the process.
Note: The "firmw
fi
Factory Settings
Restore Factory Settings restores all settings to the default factory configuration.
If at any time you wish to restore factory settings, s
S
complete the proc
Important note:
Activ
R
Factory Settings.
1
The Package Control web page is used for verifying a field
m
the installation is
specify which files are missing/corrupt.
If
available when contacting CalAmp Technical Support.
T
this page.
Figure 10.3 - Maintenance
D
Package Control Web Page
10.4 NET TESTS
The Net Tests web page allows the user to test the reliability of the RF link. Test packets
are generated and transmitted with a special Viper specific test bit set in the header to
identify the packet as a test packet. The receiving Viper listens for these test packets and
001-5008-000(Rev8) Page 99