User's Manual
Table Of Contents
- 1 VIPER OVERVIEW
- 2 SYSTEM ARCHITECTURE AND NETWORK PLANNING
- 3 DATARADIO VIPER QUICK START
- 4 VIPER WEB MANAGEMENT
- 5 UNIT STATUS
- 6 SETUP (BASIC)
- 7 SETUP (ADVANCED)
- 7.1 RF OPTIMIZATIONS
- 7.2 IP SERVICES
- 7.3 IP ADDRESSING
- 7.4 IP OPTIMIZATION
- 7.5 IP ROUTING (TABLE/ENTRIES)
- 7.6 TIME SOURCE
- 7.7 ALARM REPORTING
- 7.8 USER SETTINGS
- 8 SECURITY
- 9 STATISTICS
- 10 MAINTENANCE
- 11 NEIGHBOR MANAGEMENT
- 12 NETWORK OPTIMIZATION
- 13 UPGRADING YOUR FIRMWARE
- VIPER SPECIFICATIONS
- PRODUCT WARRANTY
- DEFINITIONS
10 MAINTENANCE
10.1 PING TEST
The ping command is a network tool used to test whether a particular host is reachable on
P packet (echo request) to a target host and
li tening for the ICMP echo response. Ping estimates the round trip time (in ms) and records
b. Press EXECUTE button
c. Allow up to 20 seconds to handle slow, or non-responding targets
the IP network. It works by sending an ICM
s
any packet loss.
a. Enter IP Address
Figure 10.1 - Maintenance
D
Ping Test Web Page
10.2 UNIT CONFIGURATION CONTROL
The Config Control web page grants the user access to the configuration settings below. A
user must click “Proceed” to execute the commands available on this screen.
Figure 10.2 - Maintenance
D
Config Control Web Page
001-5008-000(Rev8) Page 97